Cant figure out how to remove whatever is holding the rear part of the trim, on the front fenders. I can remove all the tabs and the front screw but cant figure out how to get to whatever is holding the rear part of the trim on. Its back in an area behind the front fender well that seems to be no access to.....any help would be appreciated. This is on a plain 62 fairlane.
Ken

Did you take out the bolts by the door? Also the one under the fender

Bill I'll try & explain this better to you:
pull the wheel off, As you look back into the wheel well, see the seam that runs from top to bottom, feel along that seam, there are 3 bolt heads, undo them & that piece of metal, from the seam to the inner fender pulls out. If i recall correctly, you can now reach in there with a 3/8 or maybe its a 5/16's & undo that last trim clip.
The piece of metal that you took off, half of it holds a rubber seal that fills the gap from seam to inner fender, it stops road crud from getting up in there. Good time to replace it the rubber is rotting or sometimes missing altogether
_________________
roger powell