Joined: 11 Mar 2006
Posts: 14
Location: marysville, ohio
Z bar swivel replace?
I finally found a correct z bar that is in pretty good shape but the swivel is wore badly and has alot of play. These have some sort of permanent c clip on them . I have a bad z bar with a good swivel but how the heck would one go about removing it without damaging it and even if you did how could you reinstall it ? Any thoughts ? Mike
Sat Nov 26, 2011 11:49 pm
fairlaniac Senior Member
Joined: 16 Mar 2006
Posts: 217
Location: Denver, PA
z-bar pivot
The "C" clip should pop off either with the proper tool or a flat blade screw driver and a sharp blow on open edge of the clip. I take it you are referring to either the frame or block side pivot assembly? Do you have a picture of what you have? _________________ Doug Bender
1966 Fairlane 427/484 Stroker - Tremec TKX
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
This theme is to be used only for the promotion of Windows(TM) XP and its associated products. -
Read the full disclaimer
I, the developer, take no responsibility for use of this theme against the wishes of Microsoft(R).