The pot metal bushings on my pedal assembly have worn into the pedal support itself, resulting in significant play. I'm toying with the idea of getting the Mustang Steve ball bearing setup. Anyone gone down this route?
Hello . I have done several sets with the bearings and with just the plain bushing kits. I have never had any problems with them. Just make sure that the wear on your support is not to bad that you will still have play in the pedals after the rebuild. Dwight
Sat Nov 28, 2009 10:57 pm
COBRAJET2 Member
Joined: 29 Nov 2007
Posts: 68
Location: ORELAND, PA
I have used the Mustang Steve Bearings and it is a nice upgrade. Especially if you have a clutch with some stiff spring pressure.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
This theme is to be used only for the promotion of Windows(TM) XP and its associated products. -
Read the full disclaimer
I, the developer, take no responsibility for use of this theme against the wishes of Microsoft(R).