Author
|
Thread |
|
|
johnc118
Member
Joined: 27 Jan 2007
Posts: 89
Location: Arkansas |
Lower ball joint removal.
I have drilled the rivets out and removed two bolts for the strut rod and still the lower housing will not come out, what did I miss?
Thanks JOhn _________________ Defending the 1st amendment with the 2nd amendment.
|
Thu Aug 16, 2007 12:25 pm |
|
|
dave s
Senior Member
Joined: 10 Mar 2006
Posts: 163
Location: Tottenham Ont. Canada |
Ball joint removal
Your missing the big hammer, no seriously they are in there with an interference fit, there is a tool to remove them, you back off the lower ball joint nut, this is a threaded tool that fits between the upper and lower ball joint shafts and forces them out. Failing that support the lower control arm and drive it out with a BFH. that's if you are not going to use the ball joint again.
|
Thu Aug 16, 2007 1:48 pm |
|
|
johnc118
Member
Joined: 27 Jan 2007
Posts: 89
Location: Arkansas |
Air chisel
The lower ball joint has four spot welds in a diamond pattern. After trying to use the BFH and going nowhere I ran to town and got an air chisel, farmhand from tractor supply. $30.00 and five minutes working time the ball joint is out.
I also drilled the new ball joint and old A-arm for 3/8 grade 8 bolts slight improvement over the 5/16th that just seemed small.
Three days later and my hand is still swelled from the BFH, lol.
John _________________ Defending the 1st amendment with the 2nd amendment.
|
Sat Aug 18, 2007 12:21 pm |
|
|
dave s
Senior Member
Joined: 10 Mar 2006
Posts: 163
Location: Tottenham Ont. Canada |
Lower ball joint
Sorry I mislead you on the welds, What did you use for ball joints on the bottom? It almost looks like a Mustang can be adapted.My bottoms are OK,but I'm changing the tops tommorow.
|
Sun Aug 19, 2007 2:16 pm |
|
|
compact
Senior Member
Joined: 08 Apr 2006
Posts: 118
Location: south australia |
im curioous here too.....have you had any probs with the mod?
i went to do thi s with a close looking aussie part67 falcon and didnt like the look of it and decided to "steal" some off my other fairlane here
|
Wed Aug 22, 2007 7:42 am |
|
|