|
|
The time now is Thu Mar 28, 2024 12:04 pm |
|
|
Author
|
Thread |
|
|
cougargt
Junior Member
Joined: 21 Aug 2006
Posts: 12
|
Speedo cable length
I hate to have my first post one where I'm asking for something. But....
I'm swapping a 4 speed into my 67 HT. And I never even thought about the gear hole is on the opposite side of the tranny. So what I need to know is. What is the new length I need to run the cable? I've check AutoKrafters and Dearborn classics, and they're vague on which it should be.
|
Tue Aug 22, 2006 5:29 pm |
|
|
fairlaniac
Senior Member
Joined: 16 Mar 2006
Posts: 217
Location: Denver, PA |
Speedo cable length
6 cyl & 289 3/spd, C4 & OD is 56 inches long. (C7OZ-17260-A)
390 4/spd is 56 inches long before 9/1/66 and 63 inches after 9/1/66 (C7OZ-17260-E)
For reference a 390 w/C6 is 65 inches long (C7OZ-17260-B) _________________ Doug Bender
1966 Fairlane 427/484 Stroker - Tremec TKX
|
Tue Aug 22, 2006 5:46 pm |
|
|
cougargt
Junior Member
Joined: 21 Aug 2006
Posts: 12
|
Thanks for the quick reply. I guess I should have added that I have a 289, and the trans was suppost to be from a 66 390 gt. I guess that puts me in the 63" range. I do know the 3 speed and the C4 have the hole on the same side (drivers). With the 4 speed on the pass. side.
|
Tue Aug 22, 2006 6:02 pm |
|
|
GerryProctor
Senior Member
Joined: 10 Mar 2006
Posts: 660
Location: San Antonio, Tx |
When I did the four speed from C6 swap in my '67 390 Fairlane, I went to NAPA and ordered a cable.
|
Wed Aug 23, 2006 5:47 am |
|
|
|
Forum Rules:
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|
|
|
|
|
|
|