Author
|
Thread |
|
|
64 Thunderbolt
Junior Member
Joined: 12 Feb 2011
Posts: 35
Location: Rocky Mount, Va |
What years will interchange with a 64
I'm searching yards for stick shift parts to swap from a Auto to a 4 speed.
My question is what years will swap with a 64?
I'm looking for:
steering column
clutch pedals
z-bar
whatever else I need for the swap _________________ David Alger
64 Fairlane 500
67 Fairlane 500
|
Tue Dec 06, 2011 8:44 am |
|
|
Bill62
Senior Member
Joined: 30 May 2006
Posts: 278
|
I think 62-65 are close
|
Wed Dec 07, 2011 6:25 am |
|
|
351bolt
Junior Member
Joined: 16 May 2006
Posts: 30
Location: Washington |
Steering column-- If you have one piece shaft, 65-66 Mustang will fit or just use the top pieces on your 64 coulmn
Clutch pedals are 64 only I think
Z bar not sure
Need a 4spd 64 fairlane tranny mount and floor hump piece which Crites has _________________ 64 2dr Sedan, 418W, C4, 3.70, Street/Strip, under construction
|
Fri Dec 09, 2011 7:02 pm |
|
|
64 Thunderbolt
Junior Member
Joined: 12 Feb 2011
Posts: 35
Location: Rocky Mount, Va |
351bolt, so what your saying is I can use a 65-66 Mustang column for the factory look of a 4 speed? _________________ David Alger
64 Fairlane 500
67 Fairlane 500
|
Fri Dec 23, 2011 11:25 am |
|
|
351bolt
Junior Member
Joined: 16 May 2006
Posts: 30
Location: Washington |
Thats what I used when I did mine, when I went to floor shifted auto. I have the on piece shaft box so I don't know if it will work with the rag joint box.
Pete _________________ 64 2dr Sedan, 418W, C4, 3.70, Street/Strip, under construction
|
Tue Jan 10, 2012 1:31 pm |
|
|
roger
Senior Member
Joined: 09 Mar 2006
Posts: 1008
Location: ontario, canada |
interchangeable parts
62-65's same chassis
I;ve got 65 clutch/brake pedals, bolted in to my 62
I haven;t tried to hook up the array of arms, bushings, Z bar ,etc but looks same as my 62 clutch stuff.
just replacing the bushings, small parts is to much of a pain,
I;m goin to use hydralic clutch , just ease of instal, pedal feel is 100% better too _________________ roger powell
|
Fri Jan 13, 2012 12:45 am |
|
|
|