Joined: 29 Aug 2007
Posts: 64
Location: Guelph, Ontario, Canada
rim question
so i am planning on runnning a 17 inch wheel on my 63 fairlane, i am air bagging it so i need to know what kind of offset will clean when the car is layed out from what i understand the patteren is 5 X 4.5 ?? so what would be the optimum offset? i like the new like 06 mustang bullet wheels
lmk thanks
Fri Jul 11, 2008 10:53 pm
steve Senior Member
Joined: 12 Mar 2006
Posts: 220
Location: ontario
Rick The new bullit wheels will work if you use the spacer/adapters in the front. I'm not sure exactly what dimension you will need though. There are some good deals on factory take offs of these wheels. _________________ Steve 64 S/C big brakes 8.8 rear 289 lentech AOD, strut front suspension
Sat Jul 12, 2008 12:23 pm
Fairlayin Member
Joined: 29 Aug 2007
Posts: 64
Location: Guelph, Ontario, Canada
ok well not 100% sure on the bullit wheels but whats is the optimum offest for the wheels not to hit the fenders whenthey go up and in that wont have to use spacers ? i am not doing anything rediculous just small 3/8's walves and only front and back just to adjust ride height because these cars look amazing lowered
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
This theme is to be used only for the promotion of Windows(TM) XP and its associated products. -
Read the full disclaimer
I, the developer, take no responsibility for use of this theme against the wishes of Microsoft(R).
