Author |
Message |
Topic: 64 Fairlane 5 speed question |
Overdrive
Replies: 1
Views: 2023
|
Forum: FairlaneTech Posted:
Sun Apr 05, 2009 11:15 pm Subject: 64 Fairlane 5 speed question |
I don't have any experience with the 4 speed.
What engine does your car have. The V8 engines in the 64 Fairlane had the 5 bolt bell housing and the narrow transmission bolt pattern. 1965 engines ha ... |
Topic: heater core |
Overdrive
Replies: 3
Views: 2081
|
Forum: FairlaneTech Posted:
Wed Mar 18, 2009 11:52 pm Subject: heater core |
This job can be completed by most owners. Take your time with cleaning and sealing.
The rubber boot that connects the heater to the fresh air duct is usually deteriorated and cannnot be reused. Rep ... |
Topic: Help! |
Overdrive
Replies: 8
Views: 2882
|
Forum: FairlaneTech Posted:
Thu Feb 12, 2009 11:40 pm Subject: Help! |
I experienced this with two spring sets that I bought about ten years ago. I compared the springs by setting one spring on top of the other set and found the locating bolt on one set was about 1/2 inc ... |
Topic: Help! |
Overdrive
Replies: 8
Views: 2882
|
Forum: FairlaneTech Posted:
Thu Feb 12, 2009 11:39 pm Subject: Help! |
I experienced this with two spring sets that I bought about ten years ago. I compared the springs by setting one spring on top of the other set and found the locating bolt on one set was about 1/2 inc ... |
Topic: Is this worth 500 bucks? |
Overdrive
Replies: 5
Views: 2512
|
Forum: FairlaneTech Posted:
Tue Jan 27, 2009 2:35 pm Subject: Is this worth 500 bucks? |
What do you want to do with the car?
My impression is the car may be worth $500 if you are looking for some body parts such as fenders and doors. Tail gates are very hard to find.
If you are th ... |
Topic: Just bought 62-have ques. |
Overdrive
Replies: 10
Views: 3726
|
Forum: FairlaneTech Posted:
Thu Dec 25, 2008 7:56 pm Subject: Just bought 62-have ques. |
I believe the transmission displayed by JMGFord has the double bolt holes that would allow it to fit behind the early 5 bolt engines and the later 6 bolt engines.
Does anyone know if all the top ... |
Topic: Just bought 62-have ques. |
Overdrive
Replies: 10
Views: 3726
|
Forum: FairlaneTech Posted:
Sun Dec 21, 2008 12:45 pm Subject: Just bought 62-have ques. |
The original Ford literature never mentioned the 260 engine in the 1962 Fairlanes - to my knowledge. Opinions differ as to the actual introduction date of the 260 engine.
The following is copied f ... |
Topic: My 62 |
Overdrive
Replies: 5
Views: 1888
|
Forum: FairlaneTech Posted:
Sat Dec 06, 2008 11:41 pm Subject: My 62 |
The 3.5 would probably be a good choice.
A 3.5 ratio will allow you to cruise at 60 mph and about 2500 rpm in 3rd gear.
In 4th gear overdrive, the engine rpm would drop about 25 per cent or abou ... |
Topic: Clutch Needed - 3sp OD 23 spline |
Overdrive
Replies: 3
Views: 2199
|
Forum: FairlaneParts Posted:
Fri Nov 14, 2008 11:08 pm Subject: Clutch Needed - 3sp OD 23 spline |
Trav,
Most of the auto parts stores do not have listings on the overdrive Fairlanes. Look in the yellow pages for a place that specializes in clutch repair. Usually this type of business stocks ... |
Topic: idle problem |
Overdrive
Replies: 4
Views: 1624
|
Forum: FairlaneTech Posted:
Mon Nov 03, 2008 11:02 am Subject: idle problem |
I am not the expert, but perhaps you can tell us what camshaft is installed?
I believe the 1406 has the electric choke and about 600cfm. |
Topic: Transmission woes |
Overdrive
Replies: 6
Views: 2683
|
Forum: FairlaneTech Posted:
Tue Oct 28, 2008 9:15 pm Subject: Transmission woes |
Most probably, a groove has worn on the outer side of the yoke and the spline area is probably ok. The groove is catching on what is left of the tail shaft bushing. Chances are a good transmission s ... |
Topic: early 289 waterpump question |
Overdrive
Replies: 10
Views: 3384
|
Forum: FairlaneTech Posted:
Tue Oct 28, 2008 11:29 am Subject: early 289 waterpump question |
Cartoad,
I live near Falcon, Co.
Larry |
Topic: early 289 waterpump question |
Overdrive
Replies: 10
Views: 3384
|
Forum: FairlaneTech Posted:
Sun Oct 26, 2008 11:14 am Subject: early 289 waterpump question |
Is this the cast iron pump with the extra bolts around the water passage or is this the aluminum pump?
My impression is the cast iron pump has the sheetmetal plate that covers the impeller. The im ... |
Topic: single barrel carb tuning |
Overdrive
Replies: 4
Views: 1643
|
Forum: FairlaneTech Posted:
Thu Oct 09, 2008 10:17 pm Subject: single barrel carb tuning |
Was any other task performed - timing changed?
Most likely
fuel level in the float bowl is too high - allows fuel to leak into intake
power enrichment valve remains open
choke is not ope ... |
Topic: 63 rearend |
Overdrive
Replies: 10
Views: 3469
|
Forum: FairlaneTech Posted:
Wed Sep 24, 2008 9:18 pm Subject: 63 rearend |
I missed the original post. What is the axle code - listed on the data plate?
I had a 62 and a 64 Fairlane with the 260 engine. The 3.5 ratio was well suited for both cars. At 60 mph, the engine in ... |
|