Author |
Message |
Topic: 66 Door handle mounting stud thread size |
66-fairlane
Replies: 0
Views: 1353
|
Forum: FairlaneTech Posted:
Fri Jul 07, 2006 3:50 pm Subject: 66 Door handle mounting stud thread size |
Have a set of door handles for my 66 that have the holes for the mounting studs full of rust. Need to know the thread size of the stud so I can run a tap in the hole and clean it up. |
Topic: 66 fairlane parts for sale |
66-fairlane
Replies: 1
Views: 3058
|
Forum: FairlaneParts Posted:
Sat Jul 01, 2006 4:33 pm Subject: 66 fairlane parts for sale |
I have the following parts for sale.
1) rear brake drums - used - 73649
2). rear backing plates, brakes and hardware - used -70399 & 70398
3.) front brake drums - used - c3da-1125b - 5L1 ... |
Topic: 66 289 fan shroud - need |
66-fairlane
Replies: 3
Views: 2531
|
Forum: Wanted Posted:
Mon Apr 03, 2006 4:41 pm Subject: 66 289 fan shroud - need |
Need fan shroud for 66 289, stick shift, no air, no power. |
Topic: remanufacture or rebuilt engine |
66-fairlane
Replies: 13
Views: 6925
|
Forum: FairlaneTech Posted:
Wed Mar 22, 2006 7:41 pm Subject: remanufacture or rebuilt engine |
Are you looking to kept it as stock looking as you can? Then go with getting the 289 rebuilt. I had mine done last winter at a local shop, they did a great job. Put in a "Lazer" cam, Windsor Jr Heads, ... |
Topic: Front Brakes (I missed the replies on woody's forum) |
66-fairlane
Replies: 10
Views: 4714
|
Forum: FairlaneTech Posted:
Sun Mar 19, 2006 8:09 pm Subject: Front Brakes (I missed the replies on woody's forum) |
Another note if you are going to a dual master cylinder. This is what I found out on my 66. Even thougt there are two lines going into the single bowl master cylinder, you should not just take those t ... |
Topic: Front Brakes (I missed the replies on woody's forum) |
66-fairlane
Replies: 10
Views: 4714
|
Forum: FairlaneTech Posted:
Sun Mar 19, 2006 4:26 pm Subject: Front Brakes (I missed the replies on woody's forum) |
Check out Stainless Steel Brakes.
http://www.ssbrakes.com
If your car came with a V8, they have kits that will bolt right onto your spindles. |
Topic: I have a good idea for a topic... |
66-fairlane
Replies: 6
Views: 5050
|
Forum: Suggestions/Questions about new forum Posted:
Fri Mar 17, 2006 5:41 pm Subject: I have a good idea for a topic... |
I agree. To have someone tell you what they had to do or what they did that wasn't right is very helpful, and "Pictures" are very, very helpful. |
|